work principle of vacuum dust collector belongs to the mechanical vibration dust collector, its basic structure is composed of fan, filter and dust collector three parts, each part is installed in a vertical frame, steel shell, baking paint rust prevention, operation, easy to use. Fan adopts centrifugal fan, large air volume, high wind pressure, and adopts noise reduction measures, low noise. The filter adopts flat cloth bag group, each cloth bag is equipped with spring steel wire mesh, the filtering effect is good. The flyaway mechanism uses the motor to drive the eccentric wheel and the connecting rod to make the cloth bag shake and clean the dust on the surface of the filter bag. The dust collector is equipped with an access door for easy maintenance and bag changing. It is mainly used for single or several points of dust removal, as well as places where the dust point is not often fixed (such as welding). The dimensions can be customized according to different needs, and customers can use the equipment without too much installation. Multi-point dust removal due to site restrictions, while the use of stand-alone dust removal equipment.

work principle of vacuum dust collector is widely used in the casting industry, ceramic industry, glass industry and non-fire materials, cement building materials, grinding wheel manufacturing, chemical products, machining and other industries of dust removal, the product is relatively significant metal chips, casting sand, Such as lathes, grinding machines, milling machines, grinding machines, polishing machines, etc., and medium specific gravity dust, such as cement, ceramic powder, gypsum powder, asbestos powder, charcoal powder, pigment, bakelite powder, plastic powder and so on. And non-fiber dust with light specific gravity have good dust removal effect, and the dust removal rate of the unit is very high.

Here is a brief overview of the work principle of vacuum dust collector installation and operation check:

A, work principle of vacuum dust collector in the factory has been quality inspection and no-load operation, so the performance requirements are in line with the requirements of the factory. However, because of the collision phenomenon may occur during the disassembly and transportation, the equipment will be deformed, and it is necessary to correct it in time, otherwise the performance of the equipment will be affected.

Two, the quality of the dust collector bag is good or bad, related to the work principle of vacuum dust collector quality and work rate, Therefore, before installation, it is necessary to check whether the joint of the dust collector bag is strong, whether there is off-line or broken line, and whether there is damage. The dust collector bag frame is the skeleton supporting the dust collector bag, and its processing quality is an important factor that directly affects the service life of the dust collector bag, which needs to be strictly checked.

Third, when using the work principle of vacuum dust collector, the reducer should be checked before installation. Once the sand debris is found, the reducer should be removed and cleaned accordingly. After assembly, it should be turned by hand. When flexible, the lubricating oil can be injected to the calibrated oil level before use.

When running the work principle of vacuum dust collector, the following points should be noted:

First, when starting the machine, first connect the compressed air to the gas storage tank, turn on the power supply, and start the ash discharge device. If there are other devices in the system, start the downstream device first. When the engine is turned off, there is no need to cut off the compressed air source. When the fan is working, it is necessary to provide compressed air to the lift valve cylinder to determine the open state of the lift valve.

The oil-water separator and the gas source triplet of the gas storage tank should be unloaded once after each class, and the oil and water separator should be cleaned every 3 to 6 months. The oil mist device should check the oil layer frequently and refuel in time. If the electromagnetic pulse valve fails, it should be removed in time. If there are impurities or moisture in it, it should be cleaned. If the diaphragm is damaged, it should be replaced promptly.

Third, when the dust collector is working normally, the ash removal device can not stop working, otherwise the dust will soon accumulate dust and overflow into the bag room, forcing the dust collector to stop working. Conventional process parameter measurement, such as smoke, gas, temperature, concentration, etc., found abnormal, should be found in time and timely treatment.

work principle of vacuum dust collector https://www.kaisenfilter.com/What-is-the-principle-of-vacuum-dust-collector-and-what-are-the-components.html